How to Install a Kayak Fish Finder

How to Install a Kayak Fish Finder

Need to place Home Page Just few Days

If you are one of those who are passionate about fishing, I am sure you would agree on fishing test your patience to the limit. With new gadgets now available in the market, fishing is no longer a patience tester. One of the products that have changed fishing experience is kayak fish finder.

What is a Kayak Fish Finder?

It’s a gadget that will help you find the fish virtually in any water type while you are on Kayak. It eliminates all the guess work from your fishing expedition and helps you locate the area where fishes are situated. Of Course, this does not take a fish to bite the hook buy you get to know where they are hiding.

How to Install Kayak Fish Finder?

You can install a fish finder by following the instruction guide below:

Step 1: Position the fish finder

Place the fish finder on the hull to make sure that the fish finder does not get on your way or compartment areas. Mark the bolt hole location by placing the mounting base where the fish finder will be mounted. While mounting doesn’t scrimp on hardware, stainless steel is good for fastening.

Step – 2: Applying the Transducer Cable

Place the transducer cable amid of the four bolts and map it. Using a sharpie, mark the transducer cable and bolt holes so that it can be easily recognized.

Step-3: Wiring

Drill two holes along each side to make holes for transducer cable. Connect transducer cable which is passing through holes from the underside and then join the power cables upwards from underneath.

Step – 4: Creating holes

Create holes for the mounting bolts. Ensure you put enough goop to the holes to stop entry of salt water. Connect the stainless steel – bolts of the mounting base with fender washers and stainless -aircraft nuts by the kayak hull to tighten use a box wrench.

Step – 5: Attaching Wires

Wires should be attached to the plug-head and then retaining clip should be connected. Attach screw of the plug head which is at the front part to the mounting base. For extension of wire use marine cable.

Soldering the wire end is much secure than crimping. With kayak- you would want to seal, seal and seal so that it stays away from salt water. Soldered joints give a strong and solid connection. Don’t leave any exposed cable ends and cover them with heat shrink to avoid any moisture.

Step – 6: Installing the Cable

Near to scupper hole find a flat surface to connect the cable. The back of the transducer should be touching the goop. Lower the cable in the form of a circular motion and then gently pushing it down to avoid forming bubbles.

Fuses should be placed along the positive line of wire. Have a look at your manual for the correct size of the fuse and keep a spare just in case.

Step 7: Enclosing the Battery

Purchasing a battery bag is recommended. Tuck in few connectors to power cable matching with wire cutters. Connect the battery to those wires matching color

As much as you do with your kayak to protect it from salt water, it will still get exposed to salt water, and you need to remove the crusty layer of slat as soon as possible. Using fresh tepid water is perhaps the easiest way. Once the salt is removed, put it in a dry environment.

So are you still wondering if you need a kayak fish finder? I am sue you do, and is interested in hiding and seek game of fishing. So go for it.

Replies: 0 / Share:

You might also like …

Post Comment

Your email address will not be published. Required fields are marked *